ESP32 Uses DSP to Simulate the Warm Sound of a Tube Amplifier

Written by

in

A Hackaday.io project uses an ESP32 and a WM8960 audio codec board to simulate the even harmonics, soft clipping, and slow volume changes of a tube amplifier through DSP. The effect is adjustable and can be bypassed. Drive can enhance harmonics from 0 to 24 dB; the builder considers approximately 14 to 16 dB optimal, as spectral measurements show the strongest second harmonics at that level. Tone adjusts the high- and low-frequency character, while Output controls the level and stores five presets.

Source:adafruit.com · Read the original

Comments

Leave a Reply

Your email address will not be published. Required fields are marked *